Operation CB, RHD
12
Connecting to 230 V mains supply
D
➤ To operate the cooler on a 230 V or 110–240 V mains supply, use the EPS-100W
(230 V) or MPS-35 (110 – 240 V) rectifier.
8Operation
I
8.1 Energy saving tips
• Choose a well ventilated installation location which is protected against direct
sunlight.
• Allow food to cool down first before placing it in the device.
• Do not open the cooling device more often than necessary.
• Do not leave the door or lid open for longer than necessary.
• Defrost the cooling device as soon as a layer of ice forms.
• Avoid unnecessarily low temperatures.
• Clean the condenser of dust impurities at regular intervals.
• Clean the lid seal regularly.
DANGER! Danger of fatal injuries!
• Never handle plugs and switches with wet hands or if you are
standing in a puddle.
• If you are operating your cooling device on board a boat with a mains
connection of 230 V from the land, you must install a ground
protection circuit breaker between the 230 V mains supply and the
cooling device.
Seek advice from a trained technician.
NOTE
Before starting your new cooling device for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please also refer to the chapter “Cleaning and maintenance” on
page 15).
RHD-CB--O-West.book Seite 12 Dienstag, 29. November 2016 11:52 11
To Next Page
Loading...
