CFX3 Operation
29
7.8 Selecting the temperature units
➤ Proceed as shown (fig. e, page 11).
7.9 Setting the temperature
A
➤ Proceed as shown (fig. f, page 12).
7.10 Using the battery protection
The device is equipped with 3-stage battery protection. The battery protection
prevents excessive discharging when the device is connected to a vehicle starter
battery or maximises the use of a supply battery.
If the cooler is operated when the vehicle ignition is switched off, the cooler switches
off automatically as soon as the supply voltage falls below a set level. The cooler will
switch back on once the battery has been recharged to the restart voltage level.
A
I
➤ Proceed as shown (fig. g, page 13).
7.11 Setting the display‘s brightness
➤ Proceed as shown (fig. h, page 13).
NOTICE! Damage hazard from excessively low temperature
Ensure that only those objects are placed in the cooler that are intended
to be cooled at the selected temperature.
NOTICE! Damage hazard
When switched off by the battery protection, the battery will no longer
be fully charged. Avoid starting repeatedly. Ensure that the battery is
recharged.
NOTE
When the cooler is supplied by a starter battery, select the battery
protection mode “MEDIUM” or “HIGH”. If the cooler is connected to a
supply battery, the battery protection mode “LOW” is ideal.
DometicCFX3_OPM_4445103157_EMEA16_202x-xx-xx.book Seite 29 Dienstag, 27. Oktober 2020 5:42 17
To Next Page
Loading...
