Dometic CFX3 25 - Setting the Bluetooth Signal and Connecting to the App; Setting the Wifi Signal and Connecting to the App; Changing CFX Name and Password in the App; Resetting the App Password (Wifi Only)

EN
Operation CFX3
32
7.15 Setting the Bluetooth signal and connecting to the
app
The cooler can be monitored and controlled via Bluetooth. To do so, you have to
pair the cooler with your Bluetooth device.
I
➤ Proceed as shown (fig. l, page 15).
7.16 Setting the WiFi signal and connecting to the app
The cooler can be monitored and controlled via WiFi direct to cooler or via a
WiFi network.
➤ Proceed as shown (fig. m, page 16) to turn WiFi on.
➤ For WiFi direct to cooler, go to device settings and select your cooler.
– The WiFi name of your cooler begins with “CFX3”.
– The preset password is “00000000”.
– You can personalise the WiFi name and the password in the CFX3 app.
I
7.17 Changing CFX name and password in the app
• You can personalise the name of your CFX in the app.
• The same name applies to both Bluetooth and WiFi.
• You can also personalise your password in the app -applicable only to WiFi.
➤ Proceed to “CFX name and password” in the app SETTINGS.
7.18 Resetting the app password (WiFi only)
• You can reset the app password to the factory setting “00000000”.
➤ Proceed as shown (fig. m, page 16).
NOTE
• Pairing must be done within the CFX3 app, not in device settings.
• There is no password required for Bluetooth connection.
NOTE
For connection via WiFi network, go to “network connection” in the app
SETTINGS.
DometicCFX3_OPM_4445103157_EMEA16_202x-xx-xx.book Seite 32 Dienstag, 27. Oktober 2020 5:42 17