CT4000 Intended use
5
A
NOTICE!
• All components of the system must be installed in frost-free areas. In
freezing temperatures, there is a risk of damage caused by frost.
• Do not use antifreeze. These agents may damage the cassette toilet.
• The operating pressure (water pressure) of the solenoid valve should
not exceed 6 bar. The solenoid valve is damaged by excessive
pressure.
• The electrical installation must comply with national and local
regulations.
In Europe: EN 1645-1, EN 1646-1, EN 1648-1, EN 1648-2
2.2 Installation instructions
The toilet must be installed so that it is accessible for service work, is easy to de-install
and install, and can be removed from the vehicle without much effort.
3 Intended use
The toilet is designed for installation and use in recreational vehicles such as camper
vans or motor caravans.
4 Technical description
The cassette toilet CTx 4xxx consists of a toilet permanently installed in the vehicle
and a removable, mobile cassette as a holding tank. The cassette is externally acces-
sible through a door. Depending on the model, the toilet is supplied with rinse water
from the vehicle-side freshwater tank or a tank integrated in the housing.
The following model versions of the toilet are available:
• CT4050: detached, without water tank, without console
• CTLP4110: detached, without water tank, low console
• CTS4110: detached, without water tank, with console
The 4050 models can be installed in a wet room.
CT4000-I-AUS.book Seite 5 Dienstag, 6. März 2018 1:18 13
To Next Page
Loading...
