Dometic CTLP4110 - Installation: Preparation; Service Door and Wall Cutouts

EN
CT4000 Installing the toilet
7
5 Installing the toilet
5.1 Installing the service door
Model-dependent installation instructions are included with the service door
( Dometic SK4, SK5).
I
5.2 Making wall cutouts
➤ Follow the instructions of the installation manual that comes with the service
door.
➤ Make a rectangular opening in the outer wall with the following dimensions
(fig. 2):
Service door wall cutout SK4:
–y = 25mm
– b = 305 mm ± 1 mm
– h = 375 mm ± 1 mm
Service door wall cutout SK5:
–y
min
= 12.5 mm, y
max
= 28 mm
– b = 310 mm ± 1 mm
– h = 360 mm ± 1 mm
The dimension x results from the placement of the toilet.
NOTE
Prepare the feed-through for the vent hose at the desired location
(chapter “Venting the cartridge tank” on page 21).
x
h
y
b
2
CT4000-I-AUS.book Seite 7 Dienstag, 6. März 2018 1:18 13