Installing the toilet CT4000
8
5.3 Setting up the toilet
A
I
➤ Install the toilet according to the description for the respective model version.
➤ Set up the toilet so that it is flush to a vertical wall only.
➤ Leave enough space so that actuation of the draining slider is not restricted.
➤ For the installation, use the dimensional drawings:
NOTICE!
All components of the system must be installed in frost-free areas. In
freezing temperatures, there is a risk of damage caused by frost.
NOTE
• When installing the toilet in a wet room, the manufacturer recom-
mends that you connect the toilet to the shower tray.
• The toilet base is equipped with a protruding collar for receiving the
upper edge of the shower tray (fig. 3).
CT4000-I-AUS.book Seite 8 Dienstag, 6. März 2018 1:18 13
To Next Page
Loading...
