DA20DC Installing the awning
17
7 Installing the awning
7.1 Required installation material
For the installation of the awning, you will need:
Drill bits: 8 mm and 11 mm
Counterbore
Metal saw
10 mm open-ended spanner or connection socket
Torque wrench
Phillips screwdriver or bit
A suitable flexible adhesive/sealant, such as Sikaflex
®
-252 for example
Cleaner recommended for use with the adhesive
Primer recommended for use with the adhesive
7.2 Installing the awning
!
WARNING! Beware of injury
Always install the mounting bracket using the supplied spacer
sleeves, shortened to 2 mm less than the thickness of the external
wall. Otherwise, the awning can break off and cause serious injury.
A
NOTICE!
Make sure that you do not damage any cables or cabinets when
drilling.
➤ Remove the awning from the premounted mounting bracket (fig. 7,
page 1).
➤ Determine the location of the installation.
In particular, check that there is enough space in the interior to mount the
backer plates at the points where the screws will be.
To Next Page
Loading...
