What to do if the temperature adjusts too quickly on my Dometic Elite Control Control Unit?
Relocate the display or the optional inside air temperature sensor of your Dometic Control Unit. Ensure the supply air should not blow on or near a sensor.
Why is the temperature displayed too high on my Dometic Elite Control Control Unit?
If the temperature displayed on your Dometic Control Unit is within 50 °F above the actual temperature, use calibration parameter 4 to adjust it. If the temperature displayed is hotter than 50 °F above the actual temperature, adjust the JP5 jumper on the unit’s circuit board.
Why does the fan on my Dometic Elite Control not run or run continuously?
If the fan on your Dometic Control Unit doesn't run or runs continuously, the digital control is set for either fan cycling with compressor or for continuous fan operation. Change the fan operation to continuous fan operation or fan cycling with compressor.
What to do if the condenser coil is iced while in HEAT mode on my Dometic Elite Control Control Unit?
If the condenser coil of your Dometic Control Unit is iced while in HEAT mode, the seawater temperature is below 40 °F (4 °C). Shut down the system to prevent damage to the condenser and allow the coil to defrost.
What does it mean if the low-pressure switch is open on my Dometic Elite Control?
Try to restart the Dometic Control Unit. The optional low-pressure switch has a ten-minute shutdown time delay that may be in effect.
General| Brand | Dometic |
|---|---|
| Model | Elite Control Series |
| Category | Control Unit |
| Language | English |
Explains the safety alert symbol used to warn of potential physical injury hazards.
Defines signal words (DANGER, WARNING, CAUTION, NOTICE) indicating hazard severity.
Lists directives for reducing accident and injury risks during installation and operation.
Provides critical safety warnings concerning electrical shock, fire, and explosion hazards.
Details plugging in the display cable and securing the panel to the bulkhead.
Guides on entering the programming menu and adjusting parameters.
To Next Page