[page 22] | gopowersolar.com
4.6.2 APP USAGE
Upon initial connection you will load into the charge controller’s main status screen. You will be able to see the SoC, Battery Type, Voltage, Current
of the controller. In addition to the main screen, there are two additional tabs “History & Alerts” to track the Ah usage and any important faults/alerts
that may occur.
4.6.1 PAIRING
When connecting for the rst time, pairing between the charge controller and the mobile device is required. Also ensure your mobile device’s Blue-
tooth® communication function is enabled. You will see the Bluetooth
®
symbol present on your status bar if so. Open the app, and the Main page
will prompt you to select devices.
Once the solar controller is powered up, please select the charge controller in the Device Selection main page of the Go Power! Connect app. The
App will prompt you to name the device for reconnection next time the app is used.
MarksRVSolar
MarksRVSolar
OPERATION
To Next Page
Loading...
