Dometic Go Power! GP-SB-PWM-30BT - Mobile App Settings Configuration

gopowersolar.com | [page 23]
Please disconnect from the controller when you are done using the app. This helps mitigate any future connection issues. To disconnect
the controller, press the “Go Power” Logo located at the top left of the app and click the red DISCONNECT button. The same button is
found at the bottom of the Status page.
For a complete list of all functionalities and instructions in the Go Power!
Connect app, visit https://gopowersolar.com/support/.
4.6.3 APP SETTINGS
In the App settings you will be able to set the battery type the solar controller is charging. The following batteries are supported below:
In addition to the charge controller settings, you will be able to set the temperature unit, reboot, force oat & absorption and reset the “Ah” history.
If you need to reset the controller to its factory settings it is located at the bottom of the APP settings page.
For custom batteries, you will be able to set custom parameters to ensure the proper custom battery prole and oat, equalization and absorption
voltages are optimal.
Please refer to the Settings Parameters section 4.3 on page 16, for more information.
Note
OPERATION
Note