Operation MasterFlush7640
12
10. Flush toilet several times and check for leaks.
11. Attach pump/base cover (fig. 5 5, page 4) to base with screws on sides
of toilet base (fig. 6, page 4) and with locking tabs on sides and back.
6 Operation
6.1 Add water to bowl
1. To add water to the toilet, press the flush pedal part way down (fig. 9,
page 5).
2. To avoid possible overflow, water flow will stop automatically if pedal is
pressed too long. More water is usually added only when flushing solids.
6.2 Flush toilet
1. To flush, press pedal down completely, then release it (fig. 9, page 5).
2. This activates a powerful macerator pump that siphons water and waste
from the toilet bowl, macerates and propels the effluent to the holding
tank.
!
I
CAUTION!
Flush only water, bodily wastes and rapid-dissolving toilet tissue.
Do not flush wet wipes, sanitary napkins, diapers, paper cups,
cotton swabs, food, hair or liquids such as oils or solvents as
clogging or damage to the toilet or toilet system may occur.
NOTE
Residual water trickle in ceramic bowls: Due to integrated rim
of this toilet bowl, water may continue to slowly trickle into toilet
bowl for up to 20 minutes after flushing. If water trickle
continues after 30 minutes, replace water valve.
Make sure all guests understand toilet operation before use.
To Next Page
Loading...
Need help?
General
