Dometic MDD 403 - Page 20

EN
Using the safe MDD403
20
Changing the anti-tamper code
A
You can change the factory-set anti-tamper code (355408). The safe must be locked
for this.
➤ Press the ENTER button twice.
➤ Enter the six digit anti-tamper code.
➤ Press the ENTER button.
✓ The display shows the message DELAY.
➤ Press the ENTER button.
➤ Enter a new six digit anti-tamper code within ten seconds.
➤ Press the ENTER button.
✓ The display shows the message REPEAT.
➤ Press the ENTER button.
➤ Repeat the entry of the new six digit anti-tamper code within ten seconds
➤ Press the ENTER button again.
NOTICE!

If you forget your anti-tamper code, nobody can access the safe any
more (not even the manufacturer). No resetting, or similar action, is
possible.

Therefore note down the anti-tamper code and store it very carefully
in a safe location.

The safe has a factory-set anti-tamper code. Change this code for
security reasons.
PIN 6X
ENTER
PIN 6X
ENTER
ENTER
PIN 6X
ENTER
ENTER
ENTER2X
Reos Code
XXXXXX
Wait 10
Reos Code
Repeat 10
DELAY
REPEAT
0'',2VERRN6HLWH'RQQHUVWDJ)HEUXDU