Refrigerator operation
The refrigerator is equipped to operate on three power modes:
Mains voltage (230V AC)
Gas (liquid gas propane/butane)
Select the desired power mode by the energy selector switch (Fig.7).
The gas burner must be inspected and cleaned as necessary at least once a year.Keep the evidence of maintenance work carried out on your refrigerator.
We recommend maintenance following an extended shutdown of the vehicle. Please contact our customer services.
The cooling unit is silent in operation.
When the appliance is first put into operation, there may be a mild odour which will disappear after a few hours.
The refrigerator will take several hours to reach its operating temperature in the cooling compartment. The freezer compartment should be cold about one hour after
switching on the refrigerator.
Cleaning
Before starting up the refrigerator, it is recommended that you clean it inside and repeat this at regular intervals. Use a soft cloth and lukewarm water with a mild detergent.
Then wipe out the appliance with clean water and dry thoroughly. To avoid material alterations, do not use soap or hard, abrasive or soda-based cleaning agents. Do not
allow the door seal to come into contact with oil or grease.
Maintenance
Work on gas and electrical equipment shall be carried out by qualified personnel only.
The gas burner must be inspected and cleaned as necessary at least once a year.Keep the evidence of maintenance work carried out on your refrigerator.
We recommend maintenance following an extended shutdown of the vehicle. Please contact our customer services.
Electrical operation
CAUTION!
This option should only be selected where the supply voltage of the connection for power supply corresponds to the value specified on the data plate. Any difference in
values may result in damage the appliance.
Gas operation (Liquid gas)
The refrigerator must be operated using liquid gas (propane, butane) (no natural gas or town gas).
For physical reasons, gas ignition faults could occur starting from an altitude above sea level of approx. 3280 ft. / 1000 m (No malfunction!)
On the initial refrigerator start-up or after a cylinder change, air may be trapped in the gas line. To purge the air from the lines, switch on the refrigerator for a short
time. The gas ignites without delay.
Each refrigerator with manual ignition is equipped with an automatic flame safety valve which interrupts the gas supply automatically after approx. 30 seconds when
the flame has extinguished.
Operation
Explanation of operating controls Manual energy selection / manual ignition Piezo-igniter:
1. Power On switch / Energy selector switch
2. Temperature controller
3. Piezo-igniter (gas)
4. Flame indicator (galvanometer)
To Next Page
Loading...
