modifications to the appliance or the use of non-original Dometic parts. The warranty does not apply if the installation and operating instructions are not adhered to and no
liability shall be entertained.
Limitation of liability
All information and guidance in these operating instructions were prepared after taking into consideration the applicable standards and regulations as well as the current
state of the art. Dometic reserves the right to make changes at any time which are deemed to be in the interest of improving the product and safety.
Dometic will assume no liability for damage in the case of :
non-observation of the operating instructions
application not in accordance with the regulations or provisions
use of non-original spare parts
improper modifications and interferences to the appliance
effect of environmental influences, such as
– temperature fluctuations
– humidity
Customer services
Dometic offers a pan-European customer service network. Find your authorised customer service centre by calling the phone number indicated in the EuroService Network
book, EuroService Network – which accompanies every refrigerator. You can also obtain the address information of the nearest customer service from
www.dometic.com. When contacting Dometic Customer Services, please state the model, product number and serial number together with the MLC code, if applicable.
You will find this information on the rating plate inside the refrigerator. We recommend that you note this data in the field provided on the front page of this operation
manual.
Spare parts
Parts can be ordered throughout Europe from our customer services.
Always give the model and product number when you contact the customer service! You will find this information on the rating plate inside the refrigerator.
Environmental notices
Ammonia (a natural compound of hydrogen and nitrogen) is used in the cooling unit as a coolant. Non-ozone-hazardous cyclopentane is used as a propellant for
manufacturing PU foam insulation.
Disposal
In order to ensure that the recyclable packaging materials are re-used, they should be sent to the customary local collection system. The appliance should be transferred
to a suitable waste disposal company that will ensure re-use of the recyclable components and proper disposal of the rest. For eco-friendly draining of the coolant from all
absorber refrigeration units, a suitable disposal plant should be used. Appliances bearing this symbol must be depo-
sited at the designated local reception point for the disposal of electrical and electronic equipment. It is not permitted that this product be disposed of by way of
the normal household refuse collection system. Dometic refrigerators bear this symbol on the data plate to be found in the interior of the unit.
Energy-saving tips
At an average ambient temperature of 25°C, it is sufficient to operate the refrigerator at middle thermostat setting.
Where possible, always store precooled products.
Do not expose the refrigerator to direct sunlight or any other heat source (e.g. heater).
Ensure that air circulation of the refrigeration unit is not obstructed.
Arrange the shelves evenly in the refrigerator (in the cooling compartment) in order to achieve the most efficient use of energy.
Maintain a clearance of approx. 10 mm between chilled products and post-evaporator (“cooling fins”).
Defrosting at regular intervals saves energy (see section 5.10 “Defrosting”).
Open the refrigerator door only for a short period of time when removing products. Run the refrigerator for about 12 hours before filling it.
To Next Page
Loading...
