Only use drinking water!
Shutting off the refrigerator
Set energy selector switch (1) to position “OFF”. The appliance is switched off
Leave the door open. It shall be slightly ajar. This is to prevent mould from forming inside the appliance.
If the refrigerator is to be taken out of service for an extended period of time, close the onboard shut-off valve and the cylinder valve .
Defrosting
As time goes by, frost builds up on the fins inside the refrigerator. A layer of frost thicker on one side may occur and does not represent a malfunction. When this layer of
frost is about 0.118 inches (3 mm) thick, the refrigerator should be defrosted..
Switch off the refrigerator, as described in section 5.9 Shutting of the refrigerator.
Remove all food and the ice cube tray.
Leave the refrigerator door open to allow air to enter and to prevent formation of mildew.
After defrosting (freezer compartment and fins free of frost), wipe both cooling compartments dry with a cloth.
Note: Water thawing in the main compartment of the refrigerator runs into an appropriate container at the back of the refrigerator. From there, the water evaporates.
CAUTION!
The layer of ice must never be removed forcibly, nor may defrosting be accelerated using a heat source!
Changing the doorhang
If it is necessary to tilt or lay the fridge onto the side, wait for one hour, before taking the fridge into operation. The cooling agent runs back into the reservoir of the cooling
unit. Thus a correct operating of the fridge is guaranteed.
To Next Page
Loading...
