Open the door, unscrew the hinge screw and keep it to hand.
Take off the door by moving it in your direction.
Loosen hinge pin and screw it in at opposite side.
Transfer distance washer on lower hinge.
Shove door into upper hinge pin and put it on lower hinge.
Screw in hinge screw.
Check that the door moves freely and the gasket seals completely when the door is closed.
Changing the decor panel
Remove the lateral ledge (1) the door (ledge is attached, not screwed).
Shift decor panel (2) away from the door and insert the new decor panel. Re-attach ledge (1)
Decor panel dimensions :
Height Width Thickness
743 +/- 0.75 mm 504 +/- 0.5 mm
min. 1.0 mm
max. 1.7 mm
Trouble-shooting
Before notifying the authorised Service Center, please check whether:
the instructions in section “Operating the refrigerator” have been observed.
the refrigerator stands level.
it is possible to operate the refrigerator with any available power source.
Failure: The refrigerator does not cool sufficiently.
Possible cause Action you can take
– Inadequate ventilation to the unit.
– Thermostat setting is too low.
– The condenser is heavily frosted.
– Too much warm food has been stored inside within short period of time.
– The appliance has been running for only a short period of time.
– Ambient temperatures too high.
– Check that the ventilation grille of the cooling unit is not covered.
– Set thermostat to a higher level.
– Check that the refrigerator door closes properly.
– Allow warm food to cool down before storage.
– Check whether the cooling compartment works after approx. 4 – 5 hours.
– Ventilate room.
Failure: The refrigerator does not cool in gas operation mode.
To Next Page
Loading...
