- 21 -
removing and replacing the shelves
Remove the shelf locks by inserting the tip of a at 1.
bladed screwdriver into the slot of the locks. Turn
the screwdriver counterclockwise and then remove
the shelf locks from the wire shelf.
Tilt the shelf to one side at an angle while pulling 2.
forward.
product care
storage compartments
cleaning
Always keep the refrigerator clean. Cleaning the refrigerator
is usually done after it is defrosted or put into storage. Use
lukewarm weak soda solution to clean the interior liner of the
refrigerator. Use warm water only to clean the nned evapora-
tor, gasket, ice tray and shelves.
To keep the refrigerator operating efciently and safely, peri-
odic inspection and cleaning of several components once or
twice a year is recommended:
Check the lower vent, upper vent and area between these •
openings for any obstructions such as bird/insect nests,
spider webs, etc.
Make sure the refrigerator area is free from combustible •
material, gasoline and other ammable vapors or liquids.
Clean the coils on the back of the refrigerator. Use a soft •
bristled brush to dust off the coils.
In order to keep the refrigerator working properly it is
important that service is performed on a regular sched-
ule. At least once a year, a qualied service technician
should inspect the connections, the control system, the
LP gas pressure and ue bafe.
defrosting
Shut off the refrigerator by pressing the main power 1.
ON/OFF button (OFF position).
Empty the refrigerator.2.
Leave the cabinet and freezer doors open and place 3.
the drip tray under the nned evaporator.
Defrosting time can be reduced by lling the ice
trays with hot water and placing them in the freezer
compartment.
When all the frost has melted, dry the interior with a 4.
clean cloth.
Replace the food and set the thermostat to the cold-5.
est setting for a few hours. Then, reset the thermostat
to the desired setting, usually at mid setting.
CAUTION
-
CAUTION
Reposition the shelf in the desired location. Insert 3.
the ends of the wire shelf on the left-hand side and
slide the shelf into the holes on the right-hand side.
Slide the plastic plugs into the holes of the wall. 4.
Snap the shelf locks onto the wire shelf.5.
To Next Page
Loading...
Need help?
General
