Dometic RM1350M - DIAGNOSTIC TEST; TO PERFORM A DIAGNOSTIC TEST

- 27 -
diagnostic test
TO PERFORM A DIAGNOSTIC TEST, FOLLOW THESE STEPS:
Turn off the refrigerator by pressing the main power ON/OFF button.1.
Press and hold the TEMP. SET button while pressing the ON/OFF button. Release buttons when display comes on.2.
Press the TEMP. SET button to step through the 5 test options. The messages are displayed ashing - alternating be-3.
tween “
TEST INDICATION” (e.g. F) and “TEST RESULT INDICATION” (e.g. E2).
no test function test
indication
test result indication
1 All outputs off.
Display shows air temperature
in fresh food compartment



Temperature sensor fault
“Unltered temperature in F”
2 Turn LAC heater on
LH 
LAC heater on
Press the lamp switch. The lamp should still be on.
3 Turn AC heater on
 

AC heater on
AC heater is off. AC is not available.
4 D+ status (if D+ is connected)
Alternator voltage
 

D+ high
D+ low
5 Run gas
LP 



Igniter and valve off. Gas hardware fault.
Igniter and valve on.
Igniter off and valve on. Flame detected
Igniter and valve off.
Gas problem. Check gas if ame is not ignited within 45 sec.
The diagnostic test should be performed by a service technician.