- 7 -
INSTALL THE SIX SCREWS IN THE FOLLOWING
ORDER:
The refrigerator is provided with a lower front strip
(shipped as a loose part). Attach the front strip after
the refrigerator is set into the cutout opening.
Install the lower front strip by sliding it under the a)
bottom hinge plates.
Secure the refrigerator and the lower front strip b)
with two screws - one screw through each hinge.
Open the doors and fasten the refrigerator with two
screws through the holes underneath the top
decoration panel.
installing the drain water hose
TO INSTALL THE DRAIN WATER HOSE, FOLLOW
THESE STEPS:
Drill a hole through ooring. It is essential that it is 1.
drilled in the cut out opening of the base plate at the
rear of the refrigerator.
Make sure that the hose does not kink when run 2.
through the oor.
Seal around the hose that goes through the drilled 3.
hole. If a longer hose than supplied is required, the
installer needs to supply one in order for the water to
drain outside of the vehicle.
Ice maker
cord (optional)
Ice maker
cord (optional)
General view. Features may vary according to model.
General view. Features may vary according to model.
installation procedure
To Next Page
Loading...
Need help?
General
