SinePower Technical description
11
The inverter can be switched to an energy-saving mode to prevent the connected
battery from discharging too quickly.
The inverter can be turned on or off using the remote control (accessory).
Additionally, the inverter can be controlled using the energy monitor (accessory).
7.1 Control elements
No. in
fig. 2
Description Description
1 Main switch 0: Switches the device permanently off
I: Switches the device permanently on
II: The device can be switched on or off via a
remote control (accessory)
2 Status LED See chapter “Status indications” on page 17
3 Fuse Protects the inverter from overload.
The fuse can be pressed in again once it has
triggered.
4 Dip switch Makes settings on the inverter
See chapter “Configuring the inverter” on
page 18
DSP1300T-3500T--IO-16s.book Seite 11 Freitag, 1. Dezember 2017 8:54 08
To Next Page
Loading...
