Operating Dometic Smart D Dometic Smart D
60
Setting brightness of the display
You can set the brightness of the display (fig. g, page 10).
To do this, proceed as follows:
➤ Slide the red bar using your finger to the required value or ...
➤ ... press the desired value.
Selecting the fresh water tank
If you have two fresh water tanks connected to the vehicle, the selection
displayed is FreshwaterPump1 and FreshwaterPump2. You can then select
the tank from which fresh water is to be pumped:
➤ Activate the required fresh water tank (FreshwaterPump1 or
FreshwaterPump2).
If you have an external fresh water source connected, you can specify that
fresh water is pumped from here:
➤ Activate the “CityWater” checkbox.
I
NOTE
When you disconnect the fresh water supply, deactivate the
checkbox and, if necessary, select the desired fresh water tank
(see above).
To Next Page
Loading...
