Setting Name Explanation
Backlash
Note Do not use this mode, if a single channel shaft encoder is
installed.
Printing will only occur when the production line moves in the forward
direction.
When the production line moves backward, printing is paused and a count
of backward encoder pulses (Current backlash count) will begin.
When the production line moves forward again, the backlash count will
count down until the count reaches zero. Printing will resume at this point.
This enables printing to resume at the point it was paused.
Note
Printing will not occur in the forward direction if the current
backlash count is positive.
Backlash
suppressed
Note Do not use this mode, if a single channel shaft encoder is
installed.
Printing will only occur when the production line moves in the forward
direction.
When the production line moves backward, printing is paused.
Printing will resume as soon as the production line moves in the forward
direction again.
Backlash forward
Note Do not use this mode, if a single channel shaft encoder is
installed.
This setting is similar to single mode. However, both signals from the
quadrature shaft encoder will be read. Backward movement will be treated
the same as forward movement, printing will occur in both directions.
INSTALLATION
73 EPT053091 - Issue 5 - 07 May 2021
To Next Page
Loading...
Need help?
General
