EasyManua.ls Logo

Donaldson Torit DFT 3-24 User Manual

Donaldson Torit DFT 3-24
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Installation
and Operation Manual
IOM AD3310701
Revision 7
Downflo
®
II
DFT 2-8, 2-12, 2-16, 2-24, 2-36
DFT 3-12, 3-24, 3-26, 3-48, 3-60, 3-72,
DFT 4-16, 4-32, 4-48, 4-64, 4-80, 4-96, 4-112, 4-128
Units Built After July 2003
Throughout this manual
statements indicating
precautions necessary
to avoid equipment failure
are referenced in a Note. Statements
indicating potential hazards that
could result in personal injury or
property damage are referenced
in a CAUTION! box.
Installation,
Operation, and
Service Information
This manual is property of the owner. Leave with the unit when set-up and start-
up are complete. Donaldson Company reserves the right to change design and
specifications without prior notice.
Question and Answer IconNeed help?

Do you have a question about the Donaldson Torit DFT 3-24 and is the answer not in the manual?

Donaldson Torit DFT 3-24 Specifications

General IconGeneral
ModelDFT 3-24
ManufacturerDonaldson Torit
TypeDust Collector
Filter TypeCartridge
ApplicationIndustrial Dust Collection
Maximum Airflow10, 000 CFM
Number of Filters3
Number of Filter Tubes24
Inlet Size (inches)Varies
DimensionsVaries by model size

Summary

Rating and Specification Information

Operation

Installation

Installation Codes and Procedures

Guidelines and compliance requirements for safe and efficient unit installation, including local codes.

Site Selection, Grade-Mounted Units

Considerations for choosing a location for grade-mounted units, including foundations and clearances.

Unit Location

Factors affecting the placement of the collector, such as hazardous conditions, foundation support, and access.

Electrical Wiring

Rigging Instructions

Typical Installation

Yoke, Venturi, and Filter Installation

Compressed Air Installation

Solid-State Timer Installation

Timer and Solenoid Specifications

Technical specifications for the solid-state timer and solenoid valves, including input and output.

Preliminary Start-Up

Filter Installation and Replacement

Filter Removal

Step-by-step instructions on how to safely remove used filter cartridges from the unit.

Filter Replacement

Optional Equipment

Magnehelic Gauge

Photohelic Gauge

Delta P Control

Delta P Plus Control

Damper and Silencer, TBI

Explosion Vents

Troubleshooting

Related product manuals