Maintenance Section
-144-
Priming the Fuel System (Diesel
Engine Only)
Bleeding the Fuel System
After changing the fuel filter, or after having serviced any
part of the fuel system, make sure that the air is bled
from the system.
1. Release the feed pump cap (1) on the injection
pump.
2. Release an air bleed nut (2) on the injection pump.
3. Operate feed pump vertical until completely remove
an air.
4. Tighten air bleed nut (2).
5. Make sure to check leakage of injection pump &
filter after operating feed pump many times.
Seat, Hood Latch & Support Cylinder
- Check, Lubricate
1. Check the operation of the seat adjuster rod. Make
sure that the seat slides freely on its track. Lightly oil
the seat slider tracks if necessary.
2. Push the lever down to raise the hood and seat
assembly. Make certain the support cylinder will
hold the hood open.
3. Lightly oil the hood latch mechanism and the rod for
the hood support cylinder.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
