Maintenance Section
-172-
6. Remove the dip stick/filter cap. Fill the drive axle
housing with oil. See “Lubricant Specification - Drive
Axle Oil” and “Refill Capacity”.
7. Start the lift truck. With the engine at low idle, place
the directional control lever to the NEUTRAL.
8. Maintain the oil level between lower mark and upper
mark on the dip stick/filter cap.
9. Install the dip stick/filter cap.
Inching & Brake Control shaft -
Lubricate
Lubricate two fittings for the inching and brake pedal
control shaft.
Horn & Lights (If Equipped) – Check
1. Press horn button, to determine if horn is
operational.
2. Check and replace all defective gauges.
3. Check all lights such as warning, directional, backup,
driving and flood lights for correct operation.
Replace all burned out bulbs. Have repairs made if
needed.
Inspect Vacuum Lines and Fittings
(LP Engine only)
1. Visually inspect vacuum lines and fittings for
physical damage such as brittleness, cracks and
kinks. Repair/replace as required.
2. Solvent or oil damage may cause vacuum lines to
become soft resulting in a collapsed line while the
engine is running.
3. If abnormally soft lines are detected, replace as
necessary.
(1) LP fuel lock-off, (2) LP regulator/converter,
(3) Fuel Trim Valve,
(4) LP mixer, (5) Vacuum lines,
(6) Coolant lines, (7) LP fuel line
5
6
4
3
2
1
7
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
