DL06K Interim Tire-4 Diesel Engine Disassembly and Reassembly of Major Components
96
3.3.11. Rear oil seal
z Install the oil seal on the crankshaft,
and assemble the oil seal, using the
oil seal jig.
3.3.12. Flywheel
z Heat the ring gear with a gas burner
evenly to inflate the ring gear, and
assemble it, using the hammer.
z Make sure that the ring gear
temperature doesn't go up over 200 °C.
z To assemble the ring wear front, heat
the ring wear front at 150 °C and
apply rock tight #262, and assemble
using the assembling jig.
z When assembling the ring wear front,
the side with the chamfered portion on
outer periphery is the front side.
z Install a guide bar on the crankshaft
bolt hole, and lift the flywheel and
adjust it to the standard pin and then,
assemble them temporarily.
z Apply the additive to the assembly
bolts (rock tight #587), and assemble
the bolts of which guide pin is not
installed. Lastly, disassemble the guide
pin, and assemble remaining bolts.
EA8M3003
Oil seal jig
EA0M4029
EK4OM019
EE1OM080
To Next Page
Loading...
