OP001013Operating Controls
2-18
7. Transmission Display
A transmission display is in the gauge panel on the dash.
The LCD indicates, gears, direction of travel, error codes,
and activated kick-down.
Figure 31, shows the transmission display in detail.
A. Indicates travel direction and gear selection. See
Figure 32 for more detailed information.
B. Indicates normal operation and error codes.
NOTE: Most codes are only two digits.
C. Indicates that error codes have occurred and are
stored.
D. Indicates that operation must be stopped immediately
to prevent damage to transmission and hazardous
operating condition.
The gear range indicator bars will indicate which gear is
selected by displaying the corresponding number of bars.
The forward and reverse indicator bars will be "OFF" when
the transmission is in "MANUAL MODE."
When transmission is in "AUTOMATIC MODE," all the
gear range indicator bars and both travel direction
indicators will be "ON."
8. Left Turn and Hazard Warning Light
This light blinks when left turn signal is turned "ON." Both
lights blink when warning lights are turned "ON."
NOTE: If left and right turn indicators blink together, or if
they blink faster than normal, a light bulb is not
operating or flasher solenoid is damaged.
F/R
20
0
10
50
km/h
30
40
0
10
5
x100r/min
30
15
20
25
STOP
FG015583
Figure 30
Figure 31
(D) (A)
(B)
(C)
Figure 32
HAAA3774
FORWARD
INDICATOR
GEAR RANGE
INDICATOR BARS
REVERSE
INDICATOR
FG004173
Figure 33
To Next Page
