Doosan GL08K - Page 26

Technical Information
- 20 -
2.3.6. Engine oil
 Check oil level with the oil level gauge and replenish if necessary.
 Check the oil level with the engine cooled. If the engine is warm, allow time for 5 ~ 10 minutes for oil
drain into the crankcase before checking oil level. The oil level must be between Max. and Min. lines
on the gauge.
 Engine oil should be changed at the specified intervals.
Oil in the oil filter cartridge should be changed simultaneously.
 The oil viscosity grades should be selected SAE No.15W40
 The following oils are also recommended
* Use only Doosan Infracore recommended engine oil.
 Engine Oil capacity
First oil change After 1,000 km (50hr) operating
Short-distance operation vehicle
(city bus, truck)
every 20,000 km
SAE No. Sulfated ash content
15W40 Bellow 0.5 %
Engine oil capacity
Engine
model
Vehicle
Oil pan inside
Total
(lit)
Max
(lit)
Min
(lit)
GL08K
Bus
ETPCA/ETPBA 17 14 20
BEB00/BEB02 14.5 10.5 20
BEB01 15.5 11.5 20
Truck 17 14 20
EA4M1008
SAE 20, 20W
SAE 10W
SAE 30
SAE 40, 50
SAE 10W - 30
SAE 5W - 20
SAE 15W - 40
SAE 10W - 40, 20W - 40, 20W - 50
-30 C
Single
grade
Ambient
temp
Multi
grade
(-20 F)
-15 C
(-0 F)
15 C
(60 F)
25 C
(80 F)
30 C
(90 F)
Engine oil viscosity - ambient temperature