EasyManuals Logo

Doosan PU086T User Manual

Doosan PU086T
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #176 background imageLoading...
Page #176 background image
- 172 -
Group Part Inspection Item
Stand value Limit
Correction Remark
for assembly for use
Radial run-out of journal
0.01
Correct Measure In horizontal
and pin with a grinder and vertical directions
Outside diameter of 83.966~
83
Use under sized
journal 83.988 bearings
Outside diameter of pin
70.971~
70
respectively(0.25,
70.990 0.5, 0.75, 1.0)
Ellipticity of journal
0.008 0.025
and pin
Concentricity of journal
0.01 0.03
and pin
Taper of journal and pin 0.01 0.03
Clearance between
0.052~0.122 0.25
Replace bearing Measure at crown
Crank crankshaft and bearing part not parting line
shaft
End play of crankshaft 0.15~0.325 0.5
Replace
thrust bearing
Adjust by a press
Measure at No.4
Run-out of crankshaft 0.1
v
l
if bended
bearing(No. 1 & 7
bearing supported)
Balance of
60
v
l
60 or Check dynamic Measure
crankshaft(g
.
cm) less balance at 400 rpm
Torque valve journal
Coat the bolt with
Clean out foreign
bearing cap bolt 30
engine oil
objects on joining
(kg
.
m) surface
Crush height of journal
Measure after
bearing
0.08~0.110 tightening metal cap
and releasing one stud
Oil seal for wear(crank Replace oil seal
Major shaft rear) if oil leaking
moving End play of con-rod 0.170 ~ 0.248 0.50 Replace con-rod
parts Clearance between con-
rod bearing and crank 0.034 ~ 0.098 0.25 Replace bearing
pin
Clearance between Measure after
small end bush & 0.050~0.081 0.12 installing the bearing
piston pin and releasing one bolt
Connec-
Crush height of con-rod
After completing of
ting rod
bearing
0.30~0.50 bearing loosen one
stud bolt & measure
Side clearance of big-
0.50 Replace con-rod
end and small-end
Allowable weight
18 g
v
l
difference per con-rods
Torque valve of
Coat the bolt with
Clean out foreign
con-rod bearing cap bolt 18
engine oil
objects on joining
(kg
.
m) surface
Diameter of cam shaft
57.86~ 57.88
journal
Clearance between cam
0.12~0.17 0.24 Replace cam bush
Cam shaft and cam bush
shaft
End play of camshaft 0.28~0.43 0.6
Replace thrust
washer
Run-out of camshaft 0.1
Correct or replace
the cam shaft
Clearance between idle
0.025~0.091 0.15
shaft bush and idle shaft
Timing End play of idle gear
0.043~0.167 0.3
Correct or replace
gear shaft gear
Back-lash between
gears(cam, idle, crank 0.16~0.28 0.35 Replace gear
and injection)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Doosan PU086T and is the answer not in the manual?

Doosan PU086T Specifications

General IconGeneral
BrandDoosan
ModelPU086T
CategoryEngine
LanguageEnglish

Related product manuals