8. General Information
8.1. General Repair Instructions
1. Before performing service operation, disconnect the grounding cable from the battery for
reducing the chance of cable damage and burning due to short-circuiting.
2. Use covers for preventing the components from damage or pollution.
3. Engine oil and anti-freeze solution must be handled with reasonable care as they cause paint
damage.
4. The use of proper tools and special tools where specified is important to efficient and reliable
service operation.
5. Use genuine DAEWOO parts necessarily.
6. Used cotter pins, gaskets, O-rings, oil seals, lock washer and self-lock nuts should be discard-
ed and new ones should be prepared for installation as normal function of the parts can not be
maintained if these parts are reused.
7. To facilitate proper and smooth reassemble operation, keep disassembled parts neatly in
groups. Keeping fixing bolts and nut separate is very important as they vary in hardness and
design depending on position of installation.
8. Clean the parts before inspection or reassembly. Also clean oil ports, etc. using compressed
air to make certain they are free from restrictions.
9. Lubricate rotating and sliding faces of parts with oil or grease before installation.
10. When necessary, use a sealer on gaskets to prevent leakage.
11. Carefully observe all specifications for bolts and nuts torques.
12. When service operation is completed, make a final check to be sure service has been done
property.
- 63 -
To Next Page
Loading...
Need help?
General
