9. Maintenance
9.1. Engine Disassembly
9.1.1. Heed at disassembly
•
Before disassembly, the part shelf should be prepared for various tools and repair parts.
•
When assembling, clean empty hand should be used and clean environment maintained.
•
In case of storing the disassembled parts, each part should not touch each other.
•
In case of disassembly, the parts should be laid in order.
9.1.2. Oil level gauge
•
Pull out the oil level gauge.
9.1.3. Cooling water
•
Remove the radiator cap. Open the
drain plug at the radiator lower part to
drain the coolant as the right figure.
Caution :
When removing radiator filler cap
while the engine is still hot, cover the
cap with a rag, then turn it slowly to
release the internal steam pressure
This will prevent a person from scald-
ing with hot steam spouted out from
the filler port.
•
Remove the drain plug from the cylin-
der block and drain out the cooling
water into a container.
- 66 -
To Next Page
Loading...
Need help?
General
