Doran 360RV User Manual

9
NOTE: To skip this section and go directly to Programming the Unit of Measure section, just
press the PROG button briefly 1 time. The display should look like Figure 2-17. Anytime during
this mode you can escape out to the next program mode by pressing the PROG momentarily.
Figure 2-11
1. The first thing that you will adjust is the Year (Y).
Pressing the SET button for 3 seconds will cause the
center digit after the Y to flash (see Figure 2-11).
This should remain a 0 until the year 2010, and then it
will be changed to a 1. Pressing the up and down
arrow buttons will adjust the value of this digit. When
you have selected the number that you want, press
the right button to adjust the right digit in the same
manner with the up and down arrow buttons. When
you have the proper number displayed for the year (Y)
press and hold the SET button for 3 seconds until the
monitor beeps twice and the display flashes twice.
(The monitor will now display like Figure 2-12.)
2. To adjust the Month (M) you will need to press and
hold the SET button until the center digit flashes. The
months will be displayed as (01) for January thru (12)
for December. Pressing the up and down arrow
buttons will adjust the value of this digit. When you
have selected the number that you want press the
right button to adjust the right digit in the same
manner with the up and down arrow buttons. When
you have the proper number displayed for the Month
(M) press and hold the SET button for 3 seconds until
the monitor beeps twice and the display flashes twice.
Figure 2-13 )
The monitor will now display like .
3. To adjust the day (d) you will need to press and
hold the SET button until the center digit flashes.
Pressing the up and down arrow buttons will adjust
the value of this digit. When you have selected the
number that you want press the right button to adjust
the right digit in the same manner with the up and
down arrow buttons. When you have the proper
number displayed for the day (d) press and hold the
Figure 2-12
Figure 2-13
II. SETUP AND INSTALLATION

Doran 360RV Specifications

Sensor Specifications

sensor transmit range	Approx. 130' (line of sight)
operating frequency	434.1 MHz FM
operating temperature range	-40 F to +257F
storage temperature range	-40F to +257F
sensor weight	Approx .85 oz
sensor dimensions	1.31 h x 1.16: diameter
sensor pressure range	10 to 188 psi +/- psi over operating pressure range
sensor low voltage shutdown	2.2 Volts

Monitor Specifications

monitor power requirements	12 VDC; Less than 100 mA when alarmed
monitor dimensions	5.7 w x 2.165 h x 1.1 d
monitor weight	5.4 oz
monitor power cord plug	Cigarette plug adapter or hard wire
monitor tire positions	1 to 36 positions
sensor alarm trigger settings	12.5% and 25% below the original tire inflation level