10
SET button for 3 seconds until the monitor beeps
twice and the display flashes twice. The display is
shown like Figure 2-14.
4. To adjust the hour (h) you will need to press and
hold the SET button until the center digit flashes.
Keep in mind that the hour will be displayed as a 24-
hour clock. An example is that 3:00 in the afternoon
will be shown on the clock as h15. Pressing the up
and down arrow buttons will adjust the value of this
digit. When you have selected the number that you
want press the right button to adjust the right digit in
the same manner with the up and down arrow buttons.
When you have the proper number displayed for the
hour (h) press and hold the SET button for 3 seconds
until the monitor beeps twice and the display flashes
twice. Figure 2-15 )
The monitor will now display like .
5. To adjust the minute (M) you will need to press and
hold the SET button until the center digit flashes. You
will notice that the Month and Minute both use the (M).
Pressing the up and down arrow buttons will adjust
the value of this digit. When you have selected the
number that you want, press the right button to adjust
the right digit in the same manner with the up and
down arrow buttons. When you have the proper
number displayed for the Minute (M) press and hold
the SET button for 3 seconds until the monitor beeps
and the display flashes twice.
Figure 2-16 )
The monitor will now
display like .
6. This will have brought you back to the (Y) years
setting. Press the PROG button momentarily to move
to the Pressure Units Programming Mode (see Figure
2-17). If you are done with the programming
operation you can press the PROG button for 5
seconds and the monitor will automatically return to
the normal mode of operation. This can be done in
any section of the program mode when the
programming is completed.
Figure 2-14
Figure 2-15
Figure 2-16
II. SETUP AND INSTALLATION
To Next Page
Loading...
Need help?
Sensor Specifications