SST FLEX ES 200
—
Safety instructions
Work on electrical equipment may only be performed
by properly qualified staff (electricians).
· Do not allow children to play with the door or its
adjustment and control devices.
· Keep remote controls out of reach of children.
· Never stick metal objects into the openings of the
operator, otherwise you might sustain an electric shock.
· Glass door leaves have to be made of safety glass.
Important technical data
Power supply 230 V AC
Fuse (by others) 16 A
Operating noise < 70 dB(A)
General
The latest versions of the common and country-specific
standards, laws, codes and regulations have to be observed.
Risk assessment
During the planning of the door system, the manufacturer
(the person installing the system) and the commissioner /
facility operator have to perform an individual risk
assessment (together).
Please refer to our homepage www.dorma.com and consider
the provided “risk assessment form” under forPRODUCT
further assistance when performing your individual risk
assessment.
Danger spots at closing edges
Automatic doors might cause hazards by crushing,
shearing, hitting and drawing-in at the different
closing edges.
Residual risk
Depending on the structural conditions, the prevailing door
version and the available safety equipment, residual risks
such as crushing and hitting (with a limited force) cannot be
excluded.
Recycling and disposal
Both the ES 200 with break-out fitting,Easy
ES 200 with break-out fitting and their packing
mainly consist of recyclable raw material.
The ES 200 with break-out fitting,Easy
ES 200 with break-out fitting and the respective
accessories must not be disposed of as domestic
waste.
Please ensure that the old appliance and the
respective accessories (if available) are properly
disposed of.
Please abide by the prevailing national statutory provisions.
1. For your safety
Main
closing edge
(HSK)
Secondary
closing edge
(NSK)
This documentation contains important information
regarding the mounting and the safe operation of the door
system.
Please read these instructions carefully before using the
break-out fitting ES 200 ES 200.with orEasy
It is important for your personal safety to abide by all
enclosed instructions.
An incorrectly performed installation might cause serious
injuries.
Using control elements, making adjustments or performing
procedures that are not described in this documentation
might cause electric shocks, danger caused by electric
voltage/current and/or danger due to mechanical incidents.
Please keep these documents for further reference and hand
them over to the person in charge in case the system is
transferred to another party.
Explanation of symbol
WARNING It indicates dangers that might cause
personal or material damage or even
kill people.
Intended application
The is only designed to open and closeSST FLEX ES 200
interior sliding doors that can provide almost the entire
width as an escape route in case of emergency by swinging
open the door leaves.
The is neither suitable for application atSST FLEX ES 200
fire doors (fire and smoke doors) nor at exterior doors.
If using the operator ES 200 Easy the admissible door panel
weight amounts up to 1 x 100 kg or 2 x 100 kg.
If using the operator ES 200 the admissible door panel
weight amounts up to 1 x 110 kg or 2 x 110 kg.
The door is suitable for application in escape routes.
The maximum cable length for external components must
not exceed 30 m.
Limitation of liability
The product may only be used according to its specified
intended application.
will not accept any liability forDORMA Deutschland GmbH
damage resulting from unauthorized modifications of the
product.
Furthermore components/accessories that have not been
approved by are exempted from liability.DORMA
5DORMA
To Next Page
Loading...
