www.doro.com
Note!
All illustraons are for illustrave purposes
only and may not accurately depict the actual
device. The items supplied with your phone might
vary depending on the soware and accessories
available in your region or oered by your service
provider. You can obtain addional accessories from
your local Doro dealer. The supplied accessories
provide the best performance with your phone.
Full user manual
For the full user manual, useful links and more
informaon please visit
www.doro.com/support/ or contact our Helpline.
1. GET STARTED
Be careful not to damage your
ngernails when you remove
the baery cover. Do not
bend or twist the baery
cover excessively as it may be
damaged.
Insert the SIM card (required)
GB
2
3
Remove the baery if it is
already installed. Locate the
SIM card holder and gently
slide the card in the holder.
See the label right next to the
holder for guidance on how
to insert the card. This device
accepts micro SIM or 3FF SIM
card. If you have problem to
remove/replace the SIM card, use adhesive tape on
the exposed part of the SIM card to pull it out.
Locate the SD card holder and gently slide the card
in the holder. The device works with or without a
SD card installed. Compable card type: microSD,
microSDHC.
4
Insert the baery by sliding it
into the baery
compartment with the
contacts facing downwards
to the right. Replace the
baery cover.
B
A
• Press (A) to conrm.
Alternavely press
selecon buon
OK
.
• Press (A) from standby
to open the phone menu.
Alternavely press le
selecon buon
Menu
to
access the phone menu.
• Press the arrow
buons (B) ,
and , , to scroll and to
select.
Enter text
• Press a numerical key repeatedly unl the
desired character is shown. Wait a few seconds
before entering the next character.
• Press
*
for a list of special characters. Select
the desired character with / and press
OK
to enter it.
• Use / to move the cursor within the text.
• Press
#
to cycle upper case, lower case and
numerals.
• Press and hold
#
to change wring language.
4. SOS CALLS
As long as the phone is switched on, it is always
possible to place an SOS call by entering the main
local emergency number for your present locaon
followed by .
5. CALL LOG
Received, missed, and dialled calls are saved in a
combined call log. 20 calls of each type can be stored
in the log. For mulple calls related to the same
number, only the most recent call is saved.
1. Press to nd your call log.
2. Use / to scroll through the call log.
=
Received call
=
Dialled call
=
Missed call
3. Press to dial, or
.
Doro 6530
Quick Start Guide
1. Earpiece
2. Headset socket
3. Charging socket
4. Le selecon buon
5. Call buon
6. Torch buon
7. Top 10
8. Voice mail
9. Microphone
10.
*
Internaonal
prex/Symbols
11.
#
Input method/
Silent
12. Camera shortcut
13. Message shortcut
14. End call /
Power on/o
15. Arrow buons/
navigaon keys
16. Right selecon
buon
17. Volume control
18. Red light = Baery
level low/Charging
19. Green light = New
message/Missed call
20. Second microphone
21. Camera ash/Torch
22. Camera lens
23. Assistance buon
24. Loudspeaker
25. External display
26. Charging stand
27. Strap mount eyelet
(strap not included)
Charge the phone
CAUTION
Only use baeries, charger and accessories that
have been approved for use with this parcular
model. Connecng other accessories may be
dangerous and may invalidate the phone’s type
approval and guarantee.
When the baery is running low, is displayed
and a warning signal is heard.
• Connect the mains adapter to a wall socket and
to the charging socket
y
or place the device
in the cradle.
Alternavely connect the cable to the charging
socket
y
on the phone and to a USB port on
a computer.
2. GET TO KNOW YOUR PHONE
1. Press and hold the red buon on the
phone to turn it on/o. Conrm with
Yes
to
power o.
2. If the SIM card is valid but protected with a PIN
code (Personal Idencaon Number),
PIN
is
displayed. Enter the PIN code and press
OK
.
Delete with
Clear
.
Note! If PIN and PUK codes were not provided with
your SIM card, please contact your service provider.
Tip: It is recommended to remove the protecve
plasc lm from the display to enhance the
visibility.
shows the number of PIN aempts le.
When no more aempts remain,
PIN blocked
is
displayed. The SIM card must now be unlocked with
the PUK code (Personal Unblocking Key).
1. Enter the PUK code and conrm with
OK
.
2. Enter a new PIN code and conrm with
OK
.
3. Re-enter the new PIN code and conrm with
OK
.
Start-up wizard
When starng the telephone for the rst me,
you can use the start-up wizard to set some basic
sengs.
Tip: You can run the start-up wizard later if you
want.
The arrow (â) indicates next acon in step-by-step
instrucons. To conrm an acon, press
OK
. To select
an item, scroll or highlight the item using /
and then press
OK
.
External display
The external display shows the me, a number of
status indicators and nocaons for incoming calls.
If the external display mes out, press and hold any
of the side keys +/- to turn it back on.
In some languages you can use the Smart ABC (T9)
input method which uses a diconary to suggest
words.
1. Press
Menu
â
â
Messages
â
.
2. Select
On
to enable, or
to disable.
3. Press
OK
to conrm.
The default language is determined by the SIM card.
Refer to the full manual on how to change language,
me and date.
Volume control
Use the side buons +/– or / to adjust
the sound volume during a call. The volume level is
indicated on the display.
Silent
Silent is a xed prole with keypad tone, message
tone and ring tone disabled, while vibraon, tasks
and alarm are unchanged.
• Press and hold
#
to acvate and to deacvate
silent.
3. CALLS
Make a call
1. Enter the phone number including the area
code. Delete with
Clear
.
2. Press to dial. Press
Abort
to cancel the
call.
3. Press to end the call.
Note! For internaonal calls, always use
+
before
the country code for best operaon. Press
*
twice
for the internaonal prex
+
.
Call from the phonebook
1. Press
Name
to open the phonebook.
2. Use / to scroll through the phonebook,
or quick search by pressing the key corresponding
to the rst leer of the name.
3. Press
â
Call,
alternavely, press
to dial the selected entry, or press
Back
to return
to standby.
Receive a call
1. Press to answer, or press
Silent
to switch
o the ring signal and then
Reject
to reject the
call (busy signal).
Alternately, press to reject the call directly.
2. Press to end the call.
During a call the selecon buons ( ) give access
to addional funcons.
Speed dial
Use
0
and
2
–
9
to speed dial an entry from
standby.
• Press and hold the corresponding buon to dial.
Add speed dial numbers
1. Press
Menu
â
â
Phonebook
â
Speed dial
.
2. Select
0
â
Add
and select an entry from the
phonebook.
3. Press
OK
to conrm.
4. Repeat to add speed dial entries for buons
2
–
9
.
6. PHONEBOOK
The Phonebook can store 500 entries with 3 phone
numbers in each entry.
Add contact
1. Press
Menu
â
Phonebook
â
-New contact-
â
Add
.
2. Enter a
Name
for the contact. Delete with
Clear
.
3. Use / to select
Mobile
,
Home
or
,
and enter the phone number(s) including the
area code.
4. When done, press
Save
.
7.
In the event of a trauma, it is crical to have this
informaon as early as possible to increase the
chances of survival. Add ICE contact to improve your
own safety. First responders can access addional
informaon such as medicaon and next of kin from
your phone in case of an emergency. All elds are
oponal, but the more informaon provided the
beer.
1. Press
Menu
â
Phonebook
â
ICE
.
2. Use / to scroll the list of entries.
3. Press
Edit
to add or edit informaon in each
entry. Delete with
Clear
.
4. Press
Save
when done.
8. ASSISTANCE BUTTON
The assistance buon allows easy access to contact
your predened help numbers should you need help.
Make sure that the assistance funcon is acvated
before use. See the full manual on how to acvate,
how to enter recipients in the numbers list, and how
to edit the text message.
Make an assistance call
1. When help is needed, press and hold the
assistance buon for 3 seconds, or press it twice
within 1 second.
The assistance call begins aer a delay of 5
seconds. In this me you can prevent a possible
false alarm by pressing .
2. If you acvate the SMS-feature, an SMS is sent
out to all your stored assistance recipients.
Note! If you acvate the SMS-feature, make sure
to write and press
OK
to save your own personal
SMS. If le blank no message will be sent.
3. All the stored recipients recieve a
.
4. The rst recipient in the list is dialled. If the call is
not answered within 25 seconds, the next number
is dialled.
Dialling is repeated 3 mes or unl the call is
answered, or unl you press .
CAUTION
When an assistance call is acvated the phone is
pre-set to handsfree mode. Do not hold the device
near your ear when the handsfree mode is in use,
because the volume may be extremely loud.
• Press
Menu
â
â
Assistance
.
9. MESSAGES
Create and send text messages
1. Press shortcut buon ,
or press
Menu
â
Messages
â
Create new
â
SMS.
2. Write your message, then press
To
.
3. Select a recipient from
Phonebook
.
Alternavely, select
Enter number
to add
recipient manually and press
Done
.
4. Select
Add
to add more recipients.
You can modify the recipients by selecng one
and press
â
Edit
/
Delete
/
Delete all
.
5. When done, press
Send
.
Create and send picture messages
Both you and the recipient must have subscrip-
ons that support picture message. The sengs
for picture message are supplied by your service
provider and can be sent to you automacally via
text message.
1. Press shortcut buon , or press
Menu
â
Messages
â
Create new
â
MMS
.
2. Write your message.
3. Press
â
Add picture:
•
My pictures
to select a le.
•
Take picture
to take a picture.
4. Press
â
Add subject
and enter your
subject, then press
Done
.
5. Press
â
To
and select recipient from
Phonebook
.
Alternavely, select
Enter number
to add
recipient manually and press
Done
.
6. Press
Add
to add more recipients.
7. Press
Send
to send.
Note! To keep best picture quality, send only one
picture per message.
• Press
Menu
â
â
Messages
.
English
3
2
4
5
7
8
16
14
17
15
13
11
12
9
23 2420
19
22
1
10
21
18
6
25
27 28