What to do if the motor piston is damaged in my dosatron D3 TRE 3000?
If the motor piston of your Dosatron Water Pump is damaged, and causing the unit to not start or stop, return unit to your service center for repair.
Why does my dosatron D3 TRE 3000 stop or not start?
If your Dosatron Water Pump stops or doesn't start, several issues could be the cause. First, the piston might be stalled; try resetting it manually. Another reason could be that air hasn't been properly bled from the unit; use the bleed button to remove any trapped air. Also, exceeding the maximum flow can cause this issue. In this case, reduce the flow and restart the unit. You can also check the piston valves seals to ensure correct position after unscrewing the top cap and taking off the piston. Finally, a damaged motor piston could be the culprit, requiring a return to the service center for repair.
What to do if water flows back into the concentrate container of my dosatron D3 TRE 3000 Water Pump?
If water is flowing back into the concentrate container of your Dosatron Water Pump, here are a few things to check: * Contaminated, worn, or missing check valve parts: Clean or replace them. * Air leak (inlet) in the suction tube: Check the tightness between the nut and suction hose. * Blocked suction tube or clogged strainer: Clean or replace it. * Missing or worn suction check valve seal: Clean or replace it. * Missing or worn plunger seal: Clean or replace it.
General| Brand | dosatron |
|---|---|
| Model | D3 TRE 3000 |
| Category | Water Pump |
| Language | English |
To Next Page
