What to do if the motor piston is damaged in my dosatron D3 RE 10?
If the motor piston of your Dosatron Water Pump is damaged, and causing the unit to not start or stop, return unit to your service center for repair.
What to do if water flows back into the concentrate container of my dosatron D3 RE 10?
If water is flowing back into the concentrate container of your Dosatron Water Pump, here are a few things to check: * Contaminated, worn, or missing check valve parts: Clean or replace them. * Air leak (inlet) in the suction tube: Check the tightness between the nut and suction hose. * Blocked suction tube or clogged strainer: Clean or replace it. * Missing or worn suction check valve seal: Clean or replace it. * Missing or worn plunger seal: Clean or replace it.
Why does my dosatron D3 RE 10 stop or not start?
If your Dosatron Water Pump stops or doesn't start, several issues could be the cause. First, the piston might be stalled; try resetting it manually. Another reason could be that air hasn't been properly bled from the unit; use the bleed button to remove any trapped air. Also, exceeding the maximum flow can cause this issue. In this case, reduce the flow and restart the unit. You can also check the piston valves seals to ensure correct position after unscrewing the top cap and taking off the piston. Finally, a damaged motor piston could be the culprit, requiring a return to the service center for repair.
Technical details including flow range, pressure, and temperature limits.
General guidelines and safety warnings for installation.
Step-by-step guide for initial setup and priming the unit.
General| Model | D3 RE 10 |
|---|---|
| Category | Water Pump |
| Operating Pressure | 0.3 - 6 bar |
| Type | Dosing Pump |
| Water Flow | 10 L/h |
| Flow Rate | 10 L/h to 3 m³/h |
| Pressure Range | 0.3 - 6 bar |
| Concentration | 0.2 - 6% |
| Injection Ratio | 1:500 - 1:50 |
| Temperature Range | 5 - 40 °C |
| Connections | BSP / NPT |
| Connection Size | 3/4" |
| Materials | Hastelloy |
To Next Page
