100
Exterior Equipment
Helm Seats
The helm and passenger seats are equipped with
a ip up bolster to provide more room between
the seats and the helm. The bolsters convert the
seats to a leaning post style seat with a backrest,
allowing the operator and passenger to sit or stand
at the helm. To convert each seat to a leaning
post, lift the front of the seat cushion to raise the
bolster and push it back above the seat cushion.
Arm rests on each side provide a more comfortable
driving position. A molded in footrest on the rear
of the console makes the helm more comfortable
when the bolsters are set to the seat position.
Side Storage/life Jacket Compartments
There are storage compartments on each side of
the cockpit. The compartments are designed to
accommodate life jackets or dunnage. Each is
accessed by a door secured with “push to close”
latches.
Forward below Deck Fishbox
An insulated shbox is located below the cockpit
sole, just forward of the console seats. The hatch
is equipped with a gas charged spring that holds
the hatch in the open position. Drain rails around
the hatch drain by gravity to a thru-hull tting in
the hull below the water line. A ush, twist lock
latch secures the hatch in the closed position.
Always make sure the hatch is closed with the
latch in the secured position before operating the
boat above idle speed.
Forward Below Deck Fishbox
Side Storage Compartment
Helm Seat Bolsters In Leaning Post PositionHelm Seat Bolsters In Seat Position
https://www.boat-manuals.com/edgewater/
To Next Page
Loading...