Dougherty Everglades 273CC - Volt Accessory Switch Panels

64
Electrical System
6.6 12 volt Accessory Switch Panels
The main accessory switch panel is located at the
helm. Most of the circuit breakers that protect the
accessories activated by the switches are located
in the head compartment breaker panel.
The switch panels are equipped with push button
switches that are labeled for the accessories they
control. An LED light built into most switches indi-
cates that the circuit is activated.
The following is a description of the accesso-
ries controlled by the main accessory switch
panel:
Horn
A momentary switch that activates the boat horn.
Nav/Anc
Press the switch once to activate the navigation
lights. Press the switch again for anchor light
only. Press the switch again to turn the lights o.
Bilge 1
Press the switch once to manually activate the
aft bilge pump located in the stern bilge near the
transom. Press the switch again to turn the pump
o. The pump moves water out through a thru-hull
tting in the hull. The pump is also activated by an
automatic oat switch that is activated whenever
the batteries are connected. This pump will run as
needed whenever the water in the bilge accumu-
lates high enough to raise the oat switch to the ON
position and turn o when the water is removed.
Bilge 2
Press the switch once to manually activate the aft
bilge pump located in the stern bilge just forward
of the aft bilge pump. Press the switch again to
turn the pump o. The pump moves water out
through a thru-hull tting in the hull. The pump
is also activated by an automatic oat switch that
is activated whenever the batteries are connected.
This pump will run as needed whenever the water
in the bilge accumulates high enough to raise the
oat switch to the ON position and turn o when
the water is removed.
Notice:
The bilge pumps will start automatically
when there is sucient water in the bilge to
activate the oat switch. Each oat switch
is protected by a fuse located in the system
compartment and is always supplied current
when the batteries are connected.
Wiper
Press the switch once to activate the windshield
wiper. Press the switch again to turn the wiper o.
Washer
Press and hold the switch to activate the solenoid
that sprays water on the windshield washer from
the fresh water system. Release the switch to
deactivate the washer.
Notice:
The fresh water system must be activated
for the windshield washer to work.
Baitwell
Press the switch once to activate the baitwell pump.
Press the switch again to turn the pump o.
Recirc
Press the switch once to activate the pump that
recirculates the water in the baitwell. Press the
switch again to turn the pump o.
Port Side Helm Switches
Starboard Side Helm Switches
https://www.boat-manuals.com/edgewater/