1. Remove the three (3) cover screws as shown in the illustration above.
2. Lift the cover carefully and disconnect the ribbon cable from the rear panel of the console as shown
in the illustration above. Put the cover and screws in a temporary safe location where they can be
found later and where the components cannot be damaged.
3. Attach the rear panel to a wall.
a. Select a location to attach the console to an indoor wall where it can be easily seen. Make
sure to keep sufficient access to the connection ports on the bottom of the console.
b. Hold the unit against the wall where it will be attached. There are four (4) mounting screw
holes in the unit (see the illustration above for the locations of the holes).
c. Use a pen to identify the screw hole locations on the wall.
d. Drill the holes at the screw hole location marks.
M2050-EU Rev.: 1 Dover Fueling Solutions
Page 17
To Next Page
Loading...