7.7 Micro SD Card
The illustration above shows the location of the Micro SD Card. The SD Card contains the operating system,
firmware, configuration and a history of the console.
IMPORTANT: Do not remove the micro SD card while the console is in operation. The
console cannot function without the SD card in place.
7.8 Close and Start Up the Console
NOTE: Be sure to connect the ribbon cable before you assemble the top and bottom sections
of the console.
1. Put the cover of the console onto the rear panel that you attached to a wall.
2. Put the cover screws into the screw holes to hold the cover on the rear panel.
3. Connect the female end of the power cord to the console and the male 3-prong connector into an
electrical wall outlet.
4. Put the Power Switch into the ON position.
Continue with the configuration as shown in the "Console Configuration" Manual.
7.9 DB9 Connections to a Management System
The console can be connected through the RS232 port Com 1 on these management systems:
DIALOG ORPAK
DOMS PIGNONE
FUEL POS (VR350 Interface) Probe emulation
GILBARCO (VR350 interface) RETALIX
M2050-EU Rev.: 1 Dover Fueling Solutions
Page 26
To Next Page
Loading...