MODULRAM DIGITAL | Edition A - Revision 0
Instruction Manual | 13
5.4 SUBSTITUTING LIGHT BULBS 5.6 CLEANING THE STEAMERS (OPTION)
5.5 CHANGING STONE
Light bulbs can only be substituted with bulbs that are 12
Volts; 20 Watts, if not, the lighting system can be damaged
By putting the lter back in its original position, it is neces-
sary to check the connecter and if it is damaged it must be
replaced.
Fig. 4.1
Loosen the screws on the right
panel.
Fig. 6.1
Loosen the back steam output.
Fig. 6.3
Loosen the water input tube.
Fig. 6.5
Remove the lter and clean the
limestone from all of the openings.
Fig. 6.2
Loosen the back panel.
Fig. 6.4
Loosen the oval ange.
Fig. 4.3
Remover the socket.
Fig. 4.2
Loosen the light bulb socket
holder.
Fig. 4.4
Substitute light bulb.
Fig. 5.1
Loosen lower frame screws.
Fig. 5.3
Remove stone.
Fig. 5.2
Remove frame.
Importante note
Warning
Important
Before starting to substitute the light bulbs, unplug the
oven from the electric socket.
Do not look directly at the light bulbs when they are tur-
ned on.
This should be done biannually.
To Next Page
Loading...
