CONTACT US AT www.DRpower.com 13
Bagger Setup
The Bagger can be installed to capture clippings for dumping at a designated
location. The Mulcher Plug and Side Discharge Chute will need to be removed
to direct clippings into the Bagger.
1. Hold the Rear Cover in the upright position (Figure 12).
Note: If you are installing the Bagger Assembly prior to operation, remove the
Mulching plug shipped in the rear of the machine (Figure 13).
2. Place the Rods of the Bagger Assembly onto the Mower Brackets on both
sides (Figure 14).
3. Lower the Rear Cover onto the Bagger Assembly. Make sure the Cover
aligns correctly and fits fully into the grooves of the Bagger Assembly.
Mulching Setup
Setting up the Mower for Mulching allows the material to remain under the
Deck longer so it can be chopped into smaller pieces. This will allow the
material to return to the lawn and decompose faster.
1. Open the Rear Cover and insert the Mulching Plug (Figure 15).
2. Remove the Side Discharge Chute to allow the Side Discharge Cover to close
(Figure 16).
To Next Page
Loading...
Need help?
General
