26 DR
®
PRO XL-DRT
Troubleshooting Table (Continued)
Tiller is difficult to control
when tilling (machine
jumps or lurches forward).
Improper tilling depth setting.
Too high engine speed on hard
ground.
Raise the tines for shallower tilling by raising the
depth regulator rod.
Set the throttle lever at lower speed.
Foreign object lodged in tines.
Tine clevis pin(s) missing.
Belt worn and/or stretched.
Pulley and idler not in correct
adjustment.
Stop tiller completely, check and discard foreign
object.
Replace tine clevis pin(s).
Replace belt.
Contact dealer.
When performing any maintenance, you must first shut off the engine, wait five (5) minutes to allow parts to cool and disconnect
the spark plug wire, keeping it away from the spark plug.
To Next Page
Loading...
