To Previous Page

75 MEIGS ROAD, P.O. BOX 25, VERGENNES, VERMONT 05491

Daily Checklist for the DR PULSE TRIMMER/MOWER

To help maintain your DR PULSE TRIMMER/MOWER for optimum performance, we recommend you follow this checklist each time you

use your machine.

[ ] MOTOR AIR COOLING SYSTEM: It is very important to keep the Motor clean of debris. Remove grass and other built-up materials

from the side and bottom air vents before, during, and after you mow. A dirty Motor retains heat and can cause damage to the internal

Motor parts.

[ ] CUTTING CORDS: Replace broken or frayed Cords.

[ ] MOW-BALL

and QUICK-LOCK Parts: Check the Mow-Ball

and Quick-Lock parts for wear and replace as needed.

[ ] GENERAL CONDITION: Check the general condition of the machine, e.g.; nuts, bolts, welds etc.

End of Season and Storage

 Check the Belt for wear.

 Clean any dirt and debris from the Trimmer/Mower, paying extra attention to the side vents and bottom vents of the motor.

 Clean any dirt and debris from the battery compartment especially vent area under the battery.

 Remove any wrapped weeds from the Mow-Ball

, Wheel Spokes, and Axle. Clean grass and debris from the top and underneath the

Trimmer Frame.

 Check to make sure the operator controls are moving freely. Lubricate the Bail Bar Cable.

Before performing any maintenance procedure or inspection, release the bail-bar to stop the motor, and remove the battery and safety key to

prevent accidental starting.

Save these instructions for future reference to ensure safe use and care of the DR PULSE TRIMMER/MOWER.

Before performing any maintenance procedure or inspection, release the bail-bar to stop the motor, and remove the battery and

safety key to prevent accidental starting.

When not in use, your DR PULSE TRIMMER/MOWER should be stored out of the reach of children and inside at a dry location.

DR PULSE Series User Manual

Questions and Answers: