Checking Readiness For Operation
56
Operating Instructions Caleo, Software 2.n
Before Each Use
Check that the side door latches securely
– Perform this test on both side doors
z Open side door slightly.
1 Then, push door back into its closed position. Turn the two
knobs outwards until they tangibly engage in the horizontal
position.
If a side door fails to remain engaged or if the red marking
remains visible:
z Take unit out of service.
Check that the double wall is firmly seated
2 Check that the double wall is securely attached to the hood.
It should not move when slightly pushed.
If the double wall is not securely attached to the hood or the
double wall or parts of the locking mechanism are damaged:
z Do not use the double wall.
z Take unit out of service.
Check the bed tilting mechanism
3 Tilt the bed.
During the tilting process, the entire housing of the Caleo must
move smoothly. Otherwise:
z Take unit out of service.
4 Return bed to a horizontal position (see page 48).
WARNING !
Always ensure that both knobs are engaged in position
in order to avoid any risk of an infant falling out of an
incubator.
The red catch behind each knob must no longer be
visible!
WARNING !
Do not reach between incubator housing and housing
support while tilting the bassinet. Risk of injury!
To Next Page
Loading...
