Dräger caleo - Using Humidity Control

Operation
81
Operating Instructions Caleo, Software 2.n
Using Humidity Control
Using Humidity Control*
z Connect the humidifier system
(see "Using Humidification Systems", page 49).
1 Press key to set humidity control.
The actual value and current setpoint of the humidity control
are displayed as bar graphs and numerical values.
Soft key symbols:
NOTE: Humidity inside the incubator is servo-controlled both
when manually setting a target value and when using AUTO
humidity.
– On activating humidity control, AUTO mode is proposed as
default.
* Available option
2 = New setpoint has not been activated.
3 off = Humidity OFF
4 manual = Set target value manually.
5 auto = Set target value automatically
(see page 159).
005
D
1
031
D
2
3 5
4
048