To Next PageTo Next Page
Need help?Do you have a question about the Dräger PIR 7200 and is the answer not in the manual?
General| Measurement Principle | Infrared (IR) |
|---|---|
| Ingress Protection | IP66 |
| Target Gas | Carbon Dioxide (CO2) |
| Output Signal | 4-20 mA, HART protocol |
| Operating Humidity | 0 to 95% RH (non-condensing) |
| Power Supply | 10 to 30 V DC |
| Certifications | ATEX, IECEx |
| Device Type | Gas transmitter |
| Operating Temperature | -40°C to +65°C (-40°F to +149°F) (depending on version) |
Follow all instructions for safe and correct use of the gas transmitter.
Safety protocols for explosive atmospheres and liability for device function.
Detailed guide for wiring, connections, and safety regulations for electrical installation.
Introduction to calibration and handling the magnetic wand.
Detailed steps for performing the zero point calibration.
Detailed steps for performing the span calibration using calibration gas.
Troubleshooting guide for issues encountered during calibration procedures.
