Dräger Polytron 3000 - User Manual

Dräger Polytron 3000
(approved as type P3S)
Transmitter for electrochemical Sensors
Instructions for Use
ST–691–2002.eps

Summary

Dr omenclature{a}ger Polytron 3000 Safety Precautions

Strictly Follow Instructions for Use

Safety in Explosion Hazard Areas

Guidelines for using equipment in potentially explosive atmospheres.

Installing the Dr omenclature{a}ger Polytron 3000 Transmitter

Preparing for Installation

Key considerations before installing the transmitter.

Installing the Docking Station

Key installation procedure for the base unit.

Electrical Connections

Crucial technical steps for wiring, including 4-20mA loop.

Installation in Explosion Hazard Areas

Critical safety installation for hazardous zones.

Installing the Measuring Unit

Procedure for attaching the main measuring unit to the docking station.

Fitting the Sensor

Final component installation and setup.

Dr omenclature{a}ger Polytron 3000 Start-up

Sensor Warm-up and Readiness

Dr omenclature{a}ger Polytron 3000 Maintenance

Maintenance Intervals and Schedule

Unit Calibration Procedure

Step-by-step guide for calibrating the transmitter unit.

Calibrating Zero Point and Sensitivity

Replacing the Sensor

Troubleshooting Dr omenclature{a}ger Polytron 3000

Fault, Cause, and Remedy Guide

Table listing common faults, their causes, and recommended remedies.

Dr omenclature{a}ger Polytron 3000 Technical Specifications

ATEX Approval Specifications

IECEx Approval Specifications

UL Approval Specifications

CSA Approval Specifications

ATEX Approval Certificate

EC-Type Examination Certificate Details

IECEx Approval Certificate

IECEx Certificate of Conformity Details

UL Approval Authorization

Notice of Authorization to Apply UL Mark

CSA Approval Certificate

CSA Certificate of Compliance Details

Declaration of Conformity

EU Declaration of Conformity Details

Dräger Polytron 3000 Specifications