Need help?Do you have a question about the Dräger Polytron 2000 and is the answer not in the manual?
General| Brand | Dräger |
|---|---|
| Model | Polytron 2000 |
| Category | Transmitter |
| Language | English |
Users must follow instructions before performing any work on the transmitter.
Transmitter must be inspected and serviced by trained personnel using genuine parts.
Only accessories listed in the order list should be used.
For stationary continuous monitoring of gas concentrations in ambient air.
Connects to Dräger or other central controllers via standard 4-20 mA signal.
Selecting a suitable mounting location is crucial for system effectiveness and performance.
Instructions for installing the MEC Key sensor adapter and DrägerSensor MEC sensor.
Transmitter initiates a warm-up phase; operation begins when the display stops flashing.
Describes 4-20 mA signal output for gas concentration and transmitter status.
Shows current gas concentration and fault/status symbols.
Defines maintenance tasks during commissioning, regular intervals, and semi-annually.
Steps and considerations for calibrating the transmitter, including zero-point and sensitivity.
Procedure for calibrating the zero-point for different sensor types.
Procedure for calibrating the sensitivity using calibration gas.
Instructions for safe disposal of electrochemical sensors as hazardous waste.
Lists common faults, their causes, and remedies for the transmitter.
Covers CE mark, signal transmission, voltage, physical, and environmental data.
Lists order numbers for measurement modules and associated sensors.
Lists order numbers for accessories, calibration equipment, and replacement parts.
To Next Page
